Configuring Wio Link/Node devices

From AMTech WikiDocs
Revision as of 15:16, 7 August 2018 by Amarrero (Talk | contribs)

Jump to: navigation, search

To configure a Wio Link or Wio Node you should use the Android/iOS app that is available in the app store. You can find more information in this page.

In order to add your Wio Link/Node devices to the AMTech platform you need to grant a wireless communication between the M2MBridge and each Wio device. To fulfill this requirement you may follow one of these alternatives:

  • Maintain the factory configuration of the default wireless interface, which is configured as a Wireless AP, and assure an Internet connection for the M2MBridge device through any other network interface or through the Digi Mesh.
  • Connect your M2MBridge to a wireless router that allows you to assign a static IP and then connect each Wio device to the same router. The static IP assigned to your M2MBridge will then be used as the custom server address for the Wio App.

To add your Wio Link/Node device to the AMTech IoT platform, you should follow these steps after the application has been installed in your phone:

  1. Configure the network in your phone to connect to the the wireless network offered by the AMTech M2MBridge device or follow any other method that allows you to be in the same network where the M2MBridge is connected. You will need to be able to get to the M2MBridge through a direct IP connection.
  2. Open the Wio App and you will see a view like this one:
    Initial view
  3. Click on "Global (new)" link to change to a custom server and type in the following address http://172.20.10.1:8080 and click on "Save":
    Customize server
    If you didn't keep the original configuration for the wireless network in the M2MBridge device then you will need to replace 172.20.10.1 for whatever other static address you configured it to have.
  4. Now type in the following email amtech@amtech.mx and password 4mt3ch. to login to the server. If everything works as expected, you will the following view:
    Logged
  5. Click on "Add your first device" button and follow the wizard:
    • Select the type of Wio device that you're adding
    • Do the indicated procedure in your Wio device to change it to configuration mode. Click on next.
      Wio add wizard
    • Configure the wireless network that your Wio device will connect to. It should be able to reach the M2MBridge through this configuration.
      Chose the wireless network for your Wio device
    • Select the Wio device network (probably something starting with Wio_) and wait for the Wio device to be configured
      Wio is configured
      Wio is configured
    • End up by typing a name for the Wio device. This name will be used later to configure this Wio device in the AMTech IoT Platform
      Configure a name
      Device has been added
  6. Once the device has been added, you will see it in the list of added devices and then you need to configure its ports. Tap the device to access this configuration and start dragging sensors to its ports resembling the same configured sensors that you have physically connect to your Wio device
    Configure ports
  7. Click on update firmware
    Updating firmware
  8. And that's it, that's all. You will end up with a configured Wio device
    Device has sensor has been added